Whether you’re replacing an old bathtub or furbishing a new bathroom, it’s important to follow the correct steps in order to install your tub properly and get it looking professionally done. With the help of his trusty tool belt and seemingly limitless know-how, Handyman Steve walks us through the five main stages of installing a bathtub, from unwrapping to putting that last bit of sealant.
Turn Off the Water
Before starting any work, turn off your home’s water supply and disconnect any water lines to your bathtub. This will save you from a messy, expensive mess later on.
Remove the Sliders
If you have any sliding doors on your tub, these will need to be removed before lifting the tub out of its alcove. It’s a good idea to lay down a bath mat to prevent damage as you’ll be moving it around quite a bit.
Remove the Old Tub
Once the drywall is removed you’ll need to disconnect any pipes running to your tub, including the drain piping and water supply line. It’s a good idea to mark the location of the drain valve, so you can access it easily in the future.
You’ll also want to remove the faucets from their spouts. Make sure you have a good plan for how to dispose of the old parts and don’t just throw them away. Leaving any part of your plumbing system in place is not safe and could lead to dangerous leaks later on.
Set the Tub
If your tub isn’t sitting perfectly level in its alcove you may need to shim it up or down to level it out. If your tub isn’t sitting level it will affect the way that it drains, which can be very costly and time consuming to fix.
Set the Drain Pipes
If you’re installing a new tub with an overflow drain, it’s important to set up the overflow drainage before you actually install your tub. The overflow drain helps to protect your walls and floor from hazardous flooding in the event that someone accidentally leaves the taps running. The overflow drain directs excess water into a drain pipe, which is then carried away from the house.
Dry-Fit the Tub
Before you install your bathtub it’s a good idea to test it out to make sure that it fits. This will give you a chance to make any adjustments in the plumbing or wall before you actually put in your tub, which will save you time and money.
It’s also a good idea to set up a ledger board. Cut a 2 by 4 in (5.1 by 10.2 cm) board to the length of the long edge of the tub and screw it to the studs on the back wall, making sure that the top of the board sits just below the flange of the tub. This will ensure that the tub is properly supported and that any sagging in the walls can be corrected.
Bathroom Renovation professional bathtub installers in Las Vegas will have a vast amount of expertise with a range of different plumbing fixtures, from faucets to toilets and showerheads. This allows them to quickly identify and resolve any problems that may occur during the bathtub installation, saving you both time and money. Plus, their thorough prep work and attention to detail ensures that the final installation is high-quality and meets all of your requirements. For more details on bathroom remodeling visit https://www.lasvegasbathroomremodeling.net/.